40mm fan mount for the All-Metal E3D v6 Hot-End to Velleman K8200/3Drag standard filament extruder.
Fan duct snap on reusing original extruder screws and spacers, optimized for robustness and easy print.
This is a remix for 40mm fan of K8200/3Drag E3D v6 HotEnd extruder mount with fan.
The 40mm fan is more quit than the standard 30mm standard.
I just ordered the Noctua NF-A4x10 FLX 40mm fan with noise level below 18dB(A), but there are other solutions out there...
Please post your experiences with this fan duct.
Update: Added STEP model for easier remix.
Print with fan mounting holes against bed.
For assembly you will need:
- 40mm standard 10mm wide case cooler fan or the one from Noctua
- 4x counter sink wood screws 2.9x19mm
- 2x M3x5mm screws for easy spacer mount (optional)
- Assembly shown on picture
Following printing setting was used:
ABS, layer height 0.3mm, 2 perimeters, 50% infill and brim.
Tip: To get the smooth surface I use acetone and apply it with a nail brush.