Arduino uno + half size breadboard holder

by Jigsawnz Mar 20, 2013
Download All Files

Thing Apps Enabled

Please Login to Comment

Nice. Only problem is that my breadboard is somehow not wide enough to be held in tightly (about 53mm breadboard in a 55min gap)

Is it collapsible?

No, it's a solid object I'm afraid.

Oh okay. thank you for the holder as it is

I made one and it works, but it's very fragile - I almost broke it removing from print bed. Some fillets might help. Regardless, thanks!

FWIW I was experiencing the same problem as @Ozy with Makerware. I ran the STL through netfabb and it printed just fine. Great little holder, thanks for the design!

Using Makerware 2.4, I get bad slices on the bottom left leg. Any idea why?


I dont know why that happens. All STL's that I upload have gone through netfab to check and correct for holes in the mesh. I use replicatorG to slice my prints.

This thing is great! Printed it in ABS on an UP! Plus. I was a little skeptical looking at it but the dimensions are perfect, the Uno and breadboard snapped right into place, don't slide around and it's quite sturdy. Minimalist design doesn't waste much plastic either, unlike some of the bulkier cases.

Thank you for your kind words. Happy prototyping.