Loading
OnkelPierre

Quanum DIY FPV Goggles Upgrade

by OnkelPierre Jan 17, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

might be a dumb question, but how did you go about making the holes for the studs and lining them up? I would think that a drill bit will tear up the foam too much.

I simply used a tube with matching diameter to drill out the holes.

I found that if you follow the directions, but not have anything connect the two halves, You can get a simple one that can be opened whenever. To attach the strap, only glue it in one half (I did bottom) and leave to dry. Then the strap can be pulled out from the bottom, too.

Is there instructions how to put this together?

Where can i find the neck strap parts that are in the 1st picture?

It's a battery mount, called: "FPV DIY Goggle Battery Holder" here On Thingiverse

And the fresnel lens holder:

http://www.thingiverse.com/thing:444925

Soporte lente Fresnell FPV Quanum

Very nice job. You took it that extra step that I wanted to go but have not had a chance to do just yet. I'm going to try to print it some time this week. Thanks.