I redesigned the clean section to fit my needs better. A mount for the fatshark 600tvl camera with a 10 degree tilt was added to the clean upper, and the gopro mount was removed from the clean lower to clean things up because I am using a mobius. I also added a ridge around the edge to help stiffen the clean lower. Still works with the stock lower sections. The mounting for the flight controller supports 30x30mm to 44x44mm hole mounting patterns.
EDIT: 1-24-15 -Added an integrated spektrum satellite receiver mount called "clean lower Sat Mount.STL"
EDIT: 6-1-15 Added STLs that are cut in half to print on beds ~125mm or bigger
Uses stock 35mm spacers and m3 hardware from the MHQ2. The fatshark camera mount is attached with 2 M3 bolts and locknuts. Mounts directly the the stock lower MHQ2 assembly using the 7mm vibration dampeners.