Lodestar strain relief
by thorry, published
Liked ByView All
Give a Shout Out
Cable strain relief for Starlight Xpress Lodestar guidecams.
Designed from scratch using Creo Elements
Remove supporting strips from below by snapping and/or cutting
Remove cables from camera
Loosen screws enough so the holder can slide in from the side
Slide in holder (note the spacing for the led, it only goes 1 way)
Tighten screws whilst holding the holder flush to the side of the camera
Insert cables into camera
Put a tie-rip where the notch is on the top in order to secure the cables
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Lodestar strain relief by thorry is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving thorry a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure thorry would love to see what you've printed. Please document your print and share a Make with the community.