Printrbot Jr SD card holder
by markbrannan, published
Liked ByView All
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
A little clip to hold your SD card adapter nearby when you're not using it.
I had initially intended this to hold the SD card square with the printbed, but I had made the tolerances too tight for the card to fit in as is. I think it actually works out better with the card at an angle, as it makes it easier to remove, but you could make it fit as intended by widening the slot by around 1Â mm.
Also, the fit onto the bed is very tight. If you want to make this a little easier, you could widen the gap between the legs by around 1Â mm and reducing the width of the clips by around 0.5Â mm each.
Printed as is, you may need to do some filing work on the legs (or sheer brute force) to get this onto the bed, but it shouldn't take too long.
The upside of the fit being so tight is that this doesn't rattle at all when the printer is in use.
Finally, to save material without impairing the function of this clip would be to halve the length of this clip as, when mounted at 45Â degrees, the SD card only protrudes into the slot about 50% of the length.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Printrbot Jr SD card holder by markbrannan is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving markbrannan a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure markbrannan would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).