Aluminatus Trinity One Heated bed wire support
by Steamerzone, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
This little clamp supports the wires comming of the heated bed, it otherwise is only held in place by the kapton heater. On my Aluminatus this caused the kapton heater to seperate from the alu heat spreader.
I've printed it in ABS with 0.3mm layer height and 33% infill without any problems.
You'll need two M3x6...M3x8 screws to clamp both parts together, the lower part has slightly smaller holes so that no nut is needed. Use a tyrap to hold the wires in place.
Place it on the bed frame adjusted so that the wires under the bed run just along the side of it, and lining up to the U part of the clamp.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Aluminatus Trinity One Heated bed wire support by Steamerzone is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Steamerzone a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Steamerzone would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).