A daft punk logo with channel for running el wire. The back of the logo has a continuous pathway for the wire. There is an exit hole at the bottom of the K, where the wire can connect up with a power supply. Dimensions and scale are specific to the wire I used, you might need to print first then find wire that can fit!
Use it in whatever way you can imagine! We stuck it to a jacket, and hid the power supply.
It is quite legible IRL, but difficult to photograph.
There is a top edge that could be printed in a different color(black/red/purple?) via filament swap. I never went back and tried this. If you decide to dual color print please post a pic as I would love to see it.
I printed in "natural" ABS. 100% infill as to better control the light. There are many bridging moments when sliced, but the gap is uniformly narrow so I didn't need to use support. When printed at its size in the STL and the above settings, the logo is relatively sturdy. That being said, the one in the pic needed minor repairs after an evening out. It is quite lightweight and easy to forget about when wearing. We made a tiny hole in the jacket and hid the battery pack on my belt. The jacket is some thin leather-like windbreaker from American Apparel. (it was on sale.)
I'll post dimensions and build photos later. Rock on.