Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
hjorthmobile

Unicorn

by hjorthmobile Feb 21, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Sympa, par contre les supports pour la tête sont trop légers pour que ça fonctionne

Tail and body printed OK (many more supports than on the picture). However, on the provided files, there is a single support for the whole head (unlike the picture). This one broke so I could not print the head and had to cancel after +5h print.

Thanks there was a mistake. New files up now.

the ones with support the rear feet dont touch bed cant print trying normal one now with cura supports

Print 3 times, failed 3 times.

The tail fall every times....

I am uploading a verision with more support around tail!

I had several failures, so I chopped her in half and printed in two pieces.

In Slic3r the rear feet are up in the air, had to trim 1.3mm off the bottom to get them all to sit right.

I had a lot of "strings" that helped the tail stay..
I'll publish a extra supported tail version !

Tail keeps falling off during print =(