The example was printed on an Orion with 1.75mm T-Glase. Printed per instructions below, it will be about 8.5 inches long, just short of the max print height of an Orion.
Slic3R settings for rocket plane:
Set X,Y, and Z Scale to 1.5x.
Set X rotation to 90 to put rocket upright.
Set Z rotation to -24 (needed for clean spiral vase slice in Slic3r)
.6mm extrusion width setting (actual nozzle is .5mm),
.4mm layer height,
.6mm extrusion width,
10mm/s speed for all modes,
Min print speed = 8mm/s
Spiral vase mode,
vertical shells: perimeters (min) = 1,
0 bottom solid layers
0 top solid layers
230C temp on the extruder, all layers
60C on bed.
Auto cooling with 0%min and 30%max fan speed
Enable fan if layer print time is < 60s
Slow down if layer print time is < 20s
Slic3r setting for end plug:
Same as for rocket plane except:
Layer height is .2mm
Bottom solid layers = 11
Top/Bottom infill pattern = Hilbert Curve (optional)