Very useful in helping to mount a box, the Shelves, canvas table frame
... easily and quickly !
Print the parts without support and position change. Put Fill density at 30% and Fill pattern into Honeycomb with a layer height of 0.3.
you will also need:
1 threaded rod M8 x 110mm
3 nuts M8
1 M3 x 15mm (or 20mm)
1 M3 nuts
You can also put a neodymium magnet in the bottom of the hole in the slide piece so that it would retract better when the drive screw is loosened
Help me replace filament and make updates, thank to tip me: PayPal me
Thanks in advance.