If you hate it when you set your sponge down when you are washing the dishes and it drips all over the counter, you may want to consider printing this out.
I have designed it with a mindful draining system so that when you are finished doing the dishes you can make sure that the sponge dries also preventing the risk of your sponge going moldy. There is a tasteful design on the holder making your kitchen look that little bit better. You can easily remove the supports with a drill. I have made it with an indent in the front/back (depends on the way you position it) so it will be simple to pick up.
This design is very versatile if will fit almost any double sink. You can adjust it after is has been printed.
I hope helps make your life that little bit easier!
You can easily install this sponge holder once it has been printed.
You will need:
2, 3 mm bolts
2, 3 mm nuts
All you do is slide the bolt through the plate and into the holder.
Then tighten up the nut.
When printing you should not have any problem with the print sticking but if you do you can rotate sponge holder piece 1 onto it's side and drill it out after.