Fairly straight forward vertical stand for the original pebble, designed to allow the straps to hang downwards instead of requiring you to feed them through gaps as required in other designs.
The connector end with magnets is secured into the printed part with a small strip of 3M 03609 VHB tape. The wire easily pushes into the groove, but with enough friction it holds itself in place. I strongly recommend you pick a place for the stand and affix it there with some Command Adhesive strips between the bottom of the stand and the surface top; the weight of the stand is not sufficient to allow you to just pull the watch off.
Printed on an UM2 with 0.2mm layer heights at 40 mm/s, 50% infill for structural rigidity, no support needed.