Taranis Antenna Mod - no dremel required

by geekaz01d Mar 20, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Worked great thanks!!

This design is very good. I printed it on a Flashforge Dreamer. 15% infill with 0.2 layer height, didn't use any supports. One of the round structures sagged a little bit though, so perhaps need a little bit of support at the area where the RPSMA connector is. I had to do some filing for the two cylinders on each side, but overall it was a good fit and the design leads to stronger antenna mounting point than the other ones posted here. Thanks!

Why the central big diameter isn't centered with the hole ?
are u sure it fit well?

In order or you to be able to get your antenna on the SMA header and also get that securing nut on there, I had to countersink the SMA well into the part so its quite proud of the top of the radio. This interfered with the edges of the part, so I offset the hole.

It fits great.

This is the best mod for this radio on thingiverse, hands down. Worked great for my X9D+.

Thanks for testing on X9D+!

I've been using this for a few weeks and it rocks. I'm very pleased with how it came out. I use large antennas on my Taranis and get 3km on X8R.

Comments deleted.