Loading
Kryp

Case for Banana Pi BPi-R1 Router + 2.5" HDD 7mm 9,5mm 12mm 15mm

by Kryp Mar 22, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Cute design but it's a no go for me because the lack of ventilation. The BPI-R1 board is known for thermal issues. I keep mine just with the top, bottom and right side acrylic covers. Perhaps this model could be mixed to add a cooler and some exhaust holes.

Your NAS looks awesome. Please Upload it when it's done. I would really like to print those things. Nice project!!!

Please note, the "cover_with_screw_mount_adapters.stl" are not connected and will print (or not print) in the air without supports. This was unexpected when I printed it.

Cool Case, only seem to have a problem with the antenna placing in the centre... the tension has caused the plastic to snap around that area, I would prefer it to be more to the end opposite to the other antenna (near the power port)

Then again I guess you didn't because of the cable length... guess that makes sense.

Very nice case, which I would like to use for my mini NAS project. I'm only a bit worried about the lack of ventilation in this case, don't you experience a build-up of heat running this 24/7?

Next to the additional Hard Disk tray (I see you're already working on ;), I would like to be able to use the Li-Ion charge controller with the back-up battery connector. Would be nice if it's possible to put a flat LiPo cell underneath the PCB.

Thanks for making this available!

Nice project ... I am trying to make a laser cut case and am wondering where you got the dimensions for the router?