by Riddellikins, published
Use This Project
Give a Shout Out
This is a simple cable clip that allows you to quickly snap a wire into a designated place so that you can find it again later. I use it to stop my charger wires from falling in between my desks.
Inspired by this thing but I thought that it looked like it wouldn't work and seemed to waste a lot of material considering what it did.
SCALE the model based on what size wire you have. The model is set for a 3mm diameter wire so use the calculation: diameter of wire / 0.03. This will give you a required scale in percentage.
PRINT one or two or three of the clips
CLEAN surfaces with alcohol wipes or methylated spirits or mineral turpentine to help the tape stay stuck for longer
STICK the clip down with double-sided tape
I AM NOT RESPONSIBLE FOR ANY SURFACES RUINED WHEN CLEANING
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Cable Clip by Riddellikins is licensed under the Creative Commons - Attribution license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Riddellikins a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Riddellikins would love to see what you've printed. Please document your print and share a Make with the community.