Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
double quick release quickfit carriage for prusa it2 belt
by Fuintur, published
Use This Project
Give a Shout Out
Fuintur's double quick release quickfit carriage for prusa it2 belt. Rotated 90 degrees. Quickfit mounting is compatible with RichRap's original.
Allows to mount the tool vertically (for tools that are so tall or are not centered, and whose mounting proccess wouldn't, otherwise, be compatible with the x smoth rods position).
LM8UU holes were enlarged to actually fit LM8UU (the Lowprofile's ones wouldn't, not in my printer at least). Goes back to zipties solution, but just fot the latch side (I was too lazy to reprint&redesign the one I had already printed). The size of the zipties holes needs some rework. Also, the hardcoded support is a a bit more difficult to remove than it should. Print the latch side as is. Print the tensioner with support (or redesign not to need support).
You will need 4 624 bearings,+ 6 M3 bolts&nuts+ 2 M4 bolts&nuts+4 LM8UU linear bearings.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
double quick release quickfit carriage for prusa it2 belt by Fuintur is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Fuintur a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Fuintur would love to see what you've printed. Please document your print and share a Make with the community.