This model is the enclosure for Gineer R&D's CremaBot. CremaBot
is a project where a Standard Jura Impressa XF50 Classic coffee
machine was converted to be an IoT device, allowing the machine
to be controlled from the web.
The cut-outs in the top half of the case line up exactly with the
CremaBot v126.96.36.199 circuit board to allow for the interface cables to and from the Jura Coffee machine, the end stops and the external
power to be routed through. The last cut-out fits a 4 pin header
directly onto the stepper motor driver if this is fitted.
Check out the full project at: http://gineer.co.za/Projects/CremaBot
I printed the model in two parts with no support material required.
Using a soldering iron I heated and sunk four M3 metal nuts for hex
screws to turn into holding the two parts securely together.