Customize this spool holder to support your filament.
Open customizer, enter the inner diameter of your spool and outer diameter of your bearing.
Compact design, quick to print.
Optional Z-Axis support block to mount the spool axle.
For best results, the spool should be snug against the holder and the bearing should be a tight fit.
2 x 608 standard bearings
Axle is 8mm threaded rod - Length should be spool width + 70mm
Nylon nuts x 4
Minimum slicer settings:
Layer height = 0.25mm
Perimeters = 2
Top/Bottom layers = 2
Infill = 20%