Loading
MarkQQ

Butterfly hair accessory

by MarkQQ Apr 20, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

The butterfly in the picture is 19cm wide. And a 3mm height is enough. You're welcome!

what scale/size is the one on your added picture ?

very nice butterfly by the way, thank you.

Hello

The print does not have sufficient adhesion:
Increase the bed temp
Clean the bed with vinegar

Send my a photo if you have pls

Mark

This is a really nice piece. The curving instructions worked beautifully, although I had to be careful to keep the bars from twisting when it bent.

One thing I haven't managed to get right yet. The antenna keep pulling up mid-print, resulting in a fluffy knot of filament. Any suggestions for getting that right?

This was my first project.
Turned out really well.

is the featured print scaled up from the stl? I printed one and it seems much smaller.

This turned out great!

The pin snapped for me during printing so I will try again printing it flat.

I used a mug with boiling water in it, dipped the piece in very hot water and moulded it around the outside of the mug to form a perfect curve.

Good design!!
We made one of these and only lefts apply curved form.
https://youtu.be/cO1GPSb2oT0
Thanks for job!