This friendly little gecko looks great on your desk or stuck to a wall with a bit of lightly adhesive putty. Prints at 100% size in less than 30 minutes at standard settings. (it looks great larger, too!) No raft or support is needed on most 3D printers.
It's easiest to remove from the print bed if you slide a palette knife or something similarly thin under the tail and gently work your way forward to get underneath the rear toes, then gently continue forward to the front legs to loosen them.
Update: The feet are now level and completely flat on the bottom.
A great way to improve both the resilience and the aesthetics of this model is to print the first few dozen layers in (white) semi-flex or PETG filament, then switch to (green) PLA. This makes the feet much less likely to break off. If you are printing in PLA only, resize to 150% for extra strength.