This is a model that prints out appx. 6" tall. It was created for a gallery show and everything worked well with my print.
There are a lot of pieces to print and glue. The majority of the pieces print without support, the only one to use it was the body. I rotated the head in my slicer software to sit on the neck, so that may work for you.
THIS WAS MODELED IN INCHES, and that was how it was exported. If you need to, scale by 25.4 for metric. You will have to refer to the images to see what goes where. I included the graphics if you want to print the lettering on clear film as I have done for the photo. The gray scale of the knot work on the panels can be printed to size and transferred with carbon paper, then gone over with colored pencils on the model. My version has lights, and someone handy can do the same.
The hinge for the neck has the hole in place for the mouth to open. Insert a cut to length sewing pin for this. I drilled another hole a little further up for a second pin and attached a rod on my model to make the head tip from pressing a button. This feature is NOT included with this model and you will have to figure this out if you want the action. Parts with numbers are the amount you need to print of that part EXCEPT for BODYBOX2-print one of these(Thingiverse changed my file names). I glued everything together with weldon and e6000 due to printing in PLA. Enjoy:)