Inspired by the mentioned models, I thought it would be nice to put my phone below the watch at night while charging.
gives the construction a solid stand and a surface for the iPhone.
iPhone 6Plus Models should also fit below.
(Tried it with a case I found here: http://www.thingiverse.com/thing:471548)
The 5S and all previous ones should fit even better.
Hope you enjoy it :-)
EDIT: gave first layers one 'mm' more so the edge is stronger
-> choose yourself, that's 1mm more infill
Please share your makes. Would like to known if you're happy with it.
The "plus 1 mm"-Version will probably raise your Watch-Stand a bit.
You might need to clean this part slightly more.
Works fine though (check my make)
You cannot tell that the stand is raised, the socket fits so tight that it won't tilt either.
The "plus 1 mm"-Version was added for Printers using 0.3 or 04 layers.
I'm printing z-0.1mm thickness so the original gives me 7 Layers at the front before separating into the steep planes; enough to be solid.
If you are printing with infill touching ground, there is no reason (besides the optical ones) to remove it. It just didn't feel right to provide a solid Model ;-)
I'm open for suggestions.
If you like it, "like it", if not:
comment and I'll try to improve