Case for Arduino Mega R3 and RAMPS 1.4 (for Prusa i3 or other).
For printing side by side!
Use nut M3 and bolt 8 or 10mm
Be careful when you insert nuts, must be on the right position otherwise you risk to break the plastic.
Hi hope nuts you have will fit well, mine are just perfect, they fit well and stay in place.
For the Arduino board on the left side you can just insert it in clips, you don't have use bolts and nuts, I did that because with my copy from China I was unable to insert a bolt, no enough space between hole and connector!
- Back side V2 (because there was not enough space for cable)
- Top side holes for fan now correct!