Remix of Proximity sensor mount for i3 Rework E3D Extruder v3 that can be mounted on the Direct drive extruder for Wilson or Prusa i3 rework.
From the original proximity sensor I moved the nut countersinks and bolt holes out so that they would fit the width of the screws. I also added 5mm to the height of the sensor so that the mount would sit in the middle of the sensor. The original needed the nut to be way near the top of the sensor. This is likely due to the height of the e3d v6 hotend so your mileage may vary.
On my Wilson the holes were not sized correctly but I didn't try to fix and just heated the nuts to melt them into the countersinks and drilled the holes out. But it works great.
Sliced in Cura with supports.