Some time ago (before I built my RepRap), I made an 'as accurate as I could manage' model of the Tardis Console room. Since then it has been cluttering up my room. I recently found some one who would take it from me. It's going to be on display at this year's (2015) 9 Worlds convention https://nineworlds.co.uk/
As a result of this I found myself thinking "What can I add that I couldn't build before?" The only major piece that I couldn't figure out how to build before was the Cathedral Clock that was a prop through the whole of series one until it had it's face melted in the episode 'Edge of Destruction'. So here it is.
29/09/18 I have added a stand for the clock so that it can be placed in my Playset (https://www.thingiverse.com/thing:3108723) I have printed this twice, once standing up without supports, and once lying down with supports. The lying down gave a cleaner result.
Rigid Ink PLA
Bronze or brown
I could have modelled this as a complete item, but to make use of the linear nature of the build, I decided to make the body from 3 pieces printed on their backs. these pieces will need gluing together. For PLA I use Humbrol Poly Cement.
The Bell is a remix printed at a scale of 0.2 due to the small size that it is being printed at, it has been modified to print out solid.
To hang the bell, using a very fine drill bit drill a hole through the towers and through the top half of the bell.
Cut a sewing pin to slightly less than the width of the 2 towers and run the pin through tower 1, then the bell and then tower 2.
Taking care not to get any glue on the bell, glue the pin into the towers.