Laser driver board mount and fan shroud for 40mm and 80mm fans. 40mm fan can be attached with M3 screws , which should thread directly into the plastic. 80mm mount will need nuts and bolts. I'm not good at designing snap fits, maybe somebody can remix it with snap fits so bolts aren't necessary?
Laser driver board should attach to the mount exactly as it comes from Jtech - no additional hardware needed.
The laser gets hot, so it would be wise to make these out of ABS instead of PLA
Here is the kit from JTech:
For the M3 screws in the 40mm shroud: you may need to feed them through the backside first to cut the threads