Camera mount is designed to fit on a HoverShip.com - "Zuul Superbeast Edition" Quad Copter Frame and fit the FoxTechFPV.com - "HoryzonHD Full HD V4 Camera". It uses a 4~5g Servo. Tested with a (Emax ES9051) and (Turnigy MX-95E) Servo.
Updates: Attached pictures aren't from the latest version. Slot alignment forward of the camera has been fixed. Also removed a bit of servo mount base in the rear. This is to allow more room around the bobbin nut that attaches to the frame back there.
V2 of the base has some small improvements. Camera fits better and screw holes alignment has been adjusted. Servo mount has been changed and screw holes added. the back corner has been removed to allow room around the nut holding clean plate to the bobbin.
The camera mount can be attached with zip ties or 2x 3mm screws in the front and the existing screw that attaches the bottom plate of the camera mount to the frame.
The BackPlate.stl attaches to the back of the camera using a standard size camera tripod screw 1/4-20 UNC. I used a 1/4"x5/16" socket set screw I got from Home Depot.
You will need a small piece of push rod or stiff piece of wire to cut to length to use to attach the back plate to the servo arm. Optionally a standard linkage stopper can be used on the servo arm to make it easier to adjust the push rod length.