FPV monitor bracket for FrSky Taranis radio

by zypher Jun 12, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Very nice set up. I had to drill the handle part using size 13/64 bit other than that it fit like a glove. Thank you.

Thank you for this design. As my needs for it were slightly different, I needed to modify it.

I have remixed it here https://www.youmagine.com/designs/zypher-taranis-mount-remix-by-nightram-for-crossfire and given you full credit for the design.

If you are unhappy with my changes, or wish for me to remove it. Let me know any time and I will.

Could you post a link to the screw used to fasten the monitor?

It's a custom screw that was provided with the monitor.
Anyway, I believe most FPV monitors comes with either 1/4" or 6mm screw socket and this bracket should work with both.
For knob check this: http://www.thingiverse.com/thing:641854 or anything else...

Knobs, based on: M3, M4, M5, M6, M8, M10 nuts and lock-nuts
by funbart

Standard camera thread is 1/4" UNC, depth is what you need.

Excellent model. Very exact dimensions, fits absolutely perfectly.
I had 40% infill and 3 perimeters I believe, this resulted in a way to tight "snap", and I have to pry it off the transmitter, unfortunately scratching the metal handle.

After some sanding, it will probably be perfect.
It is very robust!!

Thank you! Good project; It works but to print it you had me do to cut the raft you left nell'STL: is unnecessary because it prints fine without it!
Perhaps, it would be the case, you also you upload a file without that annoying base. Congratulations anyway.