A simple holder for a remote, e.g. for your projector! Designed to hold a 140x45x20 mm Acer remote but should work for many more with little or no scaling.
Also makes for a good overhang test - this design prints without supports as it features only 45° overhangs and five short gaps to bridge.
Printed in PLA with 0.3 mm layers and 30 % infill - no support, but good cooling needed.
I attached it to a beam on my IKEA shelf using hot_soup_in_space's Bongo Tie Rubber Band Cable Fasteners. A nice side effect of using rubber bands rather than zip ties is the greatly increased friction between plastic and wood which keeps your holder where you wanted it to be :-)