Loading
jukka5

Arduino Nano vertical holder

by jukka5 Jul 13, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Was too delicate, just removing the raft broke it in two places... good idea though as the Nano is good on the side like that., just reinforce the right angles and thicken up the base, maybe the base a bit wider to give it a stable platform.

Thanks for the comments! I'll give a shot at the improvements when I run out of my current batch of holders. However, i haven't have any of mine broken yet, but on the other hand I haven't done insert/removal of Nano more than once or twice per holder.

I printed mine with Ultimaker 2 using PLA and with fairly low quality settings (basically the default settings of Cura, if I remember right). The first one I printed in the standing position, but that didn't come out well. The current ones are printed so that the model is turned flat on its back - that way the thin parts are stronger and allow more flexing.

No worries. I'll try on its back, I should have thought of that. I used ABS, I will try a finer quality too (UP! 2).