Loading
Hey! This thing is still a Work in Progress. Files, instructions, and other stuff might change!
OakLab

Tippe Top

by OakLab Jul 25, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Printed out well, just had to sand the bottom. Spinned very good and even turned upside down - and an the second try the handle broke. 20% infill seem to be not enough.

Came out best when printed in two halves, with support, then glued together. Didn't spin as well when printed upside down, although it may work to print upright with ABS and HIPS support (with no gap between the two - makes for a smooth bottom surface).

Wow, never saw a top like this. I am going to try this.

Thank you very much.

Hi, can you post your print settings? I couldn't get it invert in the middle and spin. I used 20% infill and thinking that may be the reason.

Thank you very much for your comment. I can only tell you the print settings I used on the UP Plus2.
ABS, 0.2mm layer height, 'Semi-Solid Honeycomb' infill. Semi-Solid Honeycomb is the second highest infill setting.