Loading
4volt

5/16in to 5mm Printed Z-axis Coupler, Slip-on and Low-profile

by 4volt May 28, 2013
Download All Files

Thing Apps Enabled

Please Login to Comment

Could you make a version of this that supports the Printrbot Simple Maker 2013? 1/4" rod?

What were your settings for printing this? Fill type, perimeters, etc

I used 3 shells, 100% concentric infill. There is not too much area that would be infill with the narrow walls, so I suspect 3 shells and 0% infill would be fine too.

I printed this out and it seems to be pretty small. Might be because I have 0.5 Extrusion Width. Also your hotend is way to high lower that until you get a nice squish. You dont want it to be too close to where it becomes a film, check out ArtisanTony he has a perfect squish. Now anywho I will adjust this to the correct size and remix it.

If it's too big or small for your settings, don't forget you can just print it out with a slight scale (like 103%) or so.