A replacement locking bracket for a common folding camping table.
The original is easily broken when in a rush to pack up after your camping holiday. Now its easy to replace and even in PLA is more durable and less brittle than the original.
Modelled in Rhino, a very close replica of the original. I printed on an Ultimaker in PLA on a 3D-Up in ABS. They print well in this orientation but you will need to print with support material as there is a big overhang on one side of the bracket.
Use the original nuts and bolts if you can if not they are 4mm bolts.
You may need to drill out the holes a bit or just print them a percent or two larger.
You may also want to print them 100% fill (Solid) for more strength but they don't really need it.
You will need to sand the rounded ends smooth to ensure they move freely when folded.