Mouse bungee cord holder

by chrisebryan Aug 27, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Ummm, isn't the whole point of a mouse BUNGEE is that it flexes with you a little bit? The commercial version you based this on uses springs as the arms.

The point of a mouse bungee is to eliminate friction of the cable dragging over your desk. Springs also create friction if you are actually bending them, which kind of defeats the purpose of having a mouse bungee in the first place. Really it should just create enough slack and raise the cable just enough to prevent as much of it from touching your desk.

Printed it for a friend, and I have to say that its a bad model.

It has many points where it could break, and mine did in the first few seconds.
I dont understand why you made the rods so thin.

I printed 100% Infill, PLA.

Maybe ABS works better, maybe I did something wrong.
But you could do such a thing much more stable really easily. I probably will do it.

Help, i wanna try to print this, but i need help on the print settings. Is Normal quality fine? And do i need to have a print support? Thx

Hey, i used 0.2mm layer height (normal), print it at 100% infill for weight and with supports!