Loading
joshuatparr

Coin Organizer for Car Cup Holder

by joshuatparr Jun 5, 2013
Download All Files

Thing Apps Enabled

Please Login to Comment

Made one using flexible filament on a M3D Micro+ and it came out better than expected.

What's the currency this one was designed for?

Opened it in MakerBot software and it came in at 75mm diameter.

What is the diameter of the coin holder, I want to see if it will fit in my car

print doesnt look good considering its from an Ultimaker, or thats a wierd filament :)

Yeah, there was a good amount of variation in the filament. I also tried using Cura to slice it and that is what caused most of the problems. I am now using Repetier and my prints are turning out a lot better!

What happened was a lot of under extrusion. I had that problem too, and what you need to do is in cura is increase your extrusion multiplier to about 200%. (may vary)

It would come in handy at a toll booth.