Sturdier Robo3D Spool Holder

by EOD Aug 30, 2015
Download All Files

Thing Apps Enabled

Please Login to Comment

Added "Middle (Support Strut)".

Should be able to provide lower cross-member support and be enough out of the way to allow for fairly free filament movement.

Thanx Tony :)

Yes.. haven't quite figured that out and I suppose it would be true.

I rarely print objects higher than 130-150mm (though Robo supposed to go up to 200)

If you notice a lot of the Robo thingies made by other will show picture with out the top; I'm pretty sure with the right kind of materials and a little know-how the top part of the case can be replaced with a box type allowing for better height performance.

The oiler/clearer/guide thing isn't necessary though.. I'll make another attachment to provide for cross-member support and yet be fairly clear of the filament; there should be enough room between the posts to allow for good sided to side movement on top.

All good until extruder carriage gets to the top. Then your cleaner will have to go because it will prevent the filament to freely move left to right and braking off (if its PLA)
I really hate this stupid box ROBO3D has designed. Its brings so much limitations.
Would be better to just have a box.